Changes to ZFW requiers reload to take effect?

jdkjdk · ‎07-08-2010

Hi,

I'm relativily new to the IOS ZWF, and have spend a lot of time to figure out why my configs didn't work, and by mistake a router reloaded and every think worked perfectly.

My question is, if it's really nessary to reload every time you make a small change/addition to e.g.. a class-map?

I've tried to remove and re-apply the zone-member on the interfaces, and do shut and no shut, but only reload works.

Another way than reload is appreciated.

Regards, Jorgen Dam

jorge.calvo · ‎07-15-2010

Hello,

As far as I know and from the configurations I have implemented, a reload is not needed to apply changes on ZFW.

Could you please tell me what configuration did you applied and what was not working before the reload?

Regards.

jdkjdk · ‎07-15-2010

Hi, I have been posting the same question to the Firewallling discussion group, because I thought that this perhaps was the wrong group.

The solution was a bug in IOS v. 15.0.1M2, and every thing worked fine after upgrade to 15.1.0T

But thanks for your reply.

PS. is there a way to close a discussion if the author solves the question/problem him self? I don't have the "Correct Answer" button on my own feeds.

Regards.