Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
540
Views
0
Helpful
2
Replies

How to archieve configuration in ciscoworks for 4404 wireless controller

Go to solution
rana.samir
Level 1
Level 1

‎07-08-2010 07:15 AM

Hi All,

How can we archieve configuration in ciscoworks for 4404 wireless controller.

Thanks in advance.

Samir

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Joe Clarke
Cisco Employee
Cisco Employee

‎07-08-2010 04:36 PM

The WCS controllers are supported just like any other device.  Make sure you have either telnet or SSH enabled for config archive transport, then before a Sync Archive on your controllers.  RME will log into them, and run "show running-config" to extract the configuration.

View solution in original post

0 Helpful
2 Replies 2

Go to solution
Joe Clarke
Cisco Employee
Cisco Employee

‎07-08-2010 04:36 PM

The WCS controllers are supported just like any other device.  Make sure you have either telnet or SSH enabled for config archive transport, then before a Sync Archive on your controllers.  RME will log into them, and run "show running-config" to extract the configuration.

0 Helpful

Go to solution
rana.samir
Level 1
Level 1
In response to Joe Clarke

‎07-09-2010 06:47 AM

Hi Joe,

Thank you very much for your reply.

Samir

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents