SIP Hookflash not working on FXS for invoking Supp Services

paul_savage · ‎07-08-2010

Hello,

thanks for taking a look.....

Hookflash for supplimentary services using Application, Service DSAPP is not working...

Have 2 problems:

1:

If I make an outbound call from FXS phone to PSTN I can get secondary dial tone....

If I receive call from PSTN to FXS phone, I cannot initiate hookflash to get secondary dial tone. I hear the cliks and in the debug vpm all trace i cann see the hookflash occuring but as said cannot get secondary dial tone. Thoughts on problem 1 appreciated.

2:

The other things thats failing is that when an outbound call is made and hookflash is invoked I can get secondary dial tone, a second call can then be made but when the calls transfer is attempted to transfer the call either by blind or consult, nothing happens...For some reason a conference appears to work....

Any ideas as to what is happening greatly appreciated....

thanks in advance...and look forward to hearing from you with any ideas......

Paul

On FXS ports on VG887 gateway for Supplementary services....

Base config is as follows:

application

service dsapp

param dialpeer 101

param disc-toggle-time 30

param callWaiting TRUE

param callConference TRUE

param callTransfer TRUE

param blind-xfer-wait-time 10

voice-port 0

compand-type a-law

cptone GB

timing hookflash-in 200 75

station-id number +441635698816

caller-id enable

dial-peer voice 101 voip

destination-pattern .T

session protocol sipv2

session target dns:FQDN

voice-class codec 1

dtmf-relay sip-notify rtp-nte sip-kpml

fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback cisco !

dial-peer voice 10 pots

service dsapp

destination-pattern +441635698816

port 0

authentication username +441635698816@FQDN 7 00321C02055D04080A70

auppal · ‎07-10-2010

for any application to run it needs to be triggered inbound. Can you have service dsapp on the voip dialpeer it matches inbound to see if that fixes the issue. else get deb ccsip messages, deb voip ccapi inout, deb vpm signal

thanks

paul_savage · ‎07-12-2010

Thanks for the reply,

when I enabled Application, DSAPP glagablly i was able to get supplimentary services for call on hold/call retrieval, call waiting and 3 part call conference.

What i can't seem to do however is blind transfer or consult transfer...

I will try and get some time later today and get some debugs for anyone to review..

thanks for takinbg the time to review....as always, appreciated.