Policy Based NAT

Unanswered Question

Hi,

     I am trying to configure Policy base NAT , please let me know if its fine



ip nat inside source list 130 pool NAT_POOL_2


ip nat pool NAT_POOL_2 1.2.7.16 1.2.7.6 netmask 255.255.255.255


access-list 130 permit ip any any X.X.5.2 0.0.0.0


For any destination host X.X.5.2 from any source ,NATing should happen so that after NAT, IP should change to 1.2.7.6



Thanks in advance


regards

Neo         

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Nagaraja Thanthry Thu, 07/08/2010 - 09:38
User Badges:
  • Cisco Employee,

Hello,


The configuration looks good. As long as you have enabled NAT on the corresponding interfaces, I don't think you will have any problems.


Regards,


NT

Nagaraja Thanthry Thu, 07/08/2010 - 14:38
User Badges:
  • Cisco Employee,

Hello,


Seems like the only way to create the NAT pool is by giving the start and end address. I do not know of any other way to do it.


Hope this answers your question.


Regards,


NT

Actions

This Discussion