Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
681
Views
0
Helpful
4
Replies

Policy Based NAT

cisco
Level 1
Level 1

‎07-08-2010 09:25 AM - edited ‎03-04-2019 09:00 AM

Hi,

     I am trying to configure Policy base NAT , please let me know if its fine


ip nat inside source list 130 pool NAT_POOL_2


ip nat pool NAT_POOL_2 1.2.7.16 1.2.7.6 netmask 255.255.255.255


access-list 130 permit ip any any X.X.5.2 0.0.0.0

For any destination host X.X.5.2 from any source ,NATing should happen so that after NAT, IP should change to 1.2.7.6

Thanks in advance

regards

Neo         

Labels:
0 Helpful
4 Replies 4

Nagaraja Thanthry
Cisco Employee
Cisco Employee

‎07-08-2010 09:38 AM

Hello,

The configuration looks good. As long as you have enabled NAT on the corresponding interfaces, I don't think you will have any problems.

Regards,

NT

0 Helpful

cisco
Level 1
Level 1
In response to Nagaraja Thanthry

‎07-08-2010 10:52 AM

Hi,

    thanks for confirmation, just want to confirm do i need to use  ip nat pool command and mention start-ip and end-ip as same IP or there is any other way to do the same ?

regards

Neo

0 Helpful

cisco
Level 1
Level 1
In response to cisco

‎07-08-2010 12:32 PM

Hi,

     please help on this.

regards

Neo

0 Helpful

Nagaraja Thanthry
Cisco Employee
Cisco Employee
In response to cisco

‎07-08-2010 02:38 PM

Hello,

Seems like the only way to create the NAT pool is by giving the start and end address. I do not know of any other way to do it.

Hope this answers your question.

Regards,

NT

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card