Solved: SRST help

calladd03 · ‎07-09-2010

Hi guys,

I'll need some help configuring SRST.

I've set the call-manager-fallback command like this:

call-manager-fallback
secondary-dialtone 9
max-conferences 12 gain -6
transfer-system full-consult
ip source-address 10.10.0.2 port 2000
max-ephones 300
max-dn 500
system message primary SRST Fallback Active
system message secondary SRST Fallback
dialplan-pattern 1 04222..... extension-length 5

I can talk between DN but I can't get call outside.

I have a PRI link

Is there anything else that I have to configure ?

Thanks

Support Albakom · ‎07-09-2010

you must configure a pots dial peer for outgoing call

example:

dial-peer voice 1 pots

desc outgoing SRST

destination-pattern 9T

port 0/0/0:15

View solution in original post

Support Albakom · ‎07-09-2010

you must configure a pots dial peer for outgoing call

example:

dial-peer voice 1 pots

desc outgoing SRST

destination-pattern 9T

port 0/0/0:15

calladd03 · ‎07-09-2010

I configured it but still not working.

dial-peer voice 11 pots
destination-pattern 9T
direct-inward-dial
port 0/3/1:15
forward-digits all

Support Albakom · ‎07-09-2010

what say

debug isdn q931

if you dial a number to PSTN?

calladd03 · ‎07-09-2010

i've set the debug but nothing happens when I try to call.

I solved it. The port setting was not right.

Thanks

a.dementyev · ‎09-03-2010

Hi. I've the same problem.

Can You explain me what did You corect in port settings.

When my SRST router has been restarted due to power interraptions I've loss access to PSTN.

thank's

Alex

calladd03 · ‎09-04-2010

Hi Alex,

Well, the serial port that I specified was wrong. I checked the router and set the correct port.

Please put your config here maybe I can help.

Adrian