Connecting to CDM600

Unanswered Question
Jul 9th, 2010

Hello all,

I've been trying to use a Comtech Satellite Modem with a Cisco Router 2600 with a WIC-1T interface, using a CAB-530MT Cable.

I was wondering if anyone had had any experience with it.

Is there special settings for the serial interface so that it works with the modem.

As for the cable, I read somewhere on line that I was supposed to remove the pin 23 on the modem side, to have it working because so far plugging it in stops the modem.

Thanks for the help.

PS Giuslar if you read this I have a question concerning the setup you advised me on for the routing.

Nice days to all

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion