×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cisco WLC2125 Reporting Traps to a specific port

Unanswered Question
Jul 9th, 2010
User Badges:

Hi all,


I am currently looking into reporting options for my Cisco WLC2125. From what I can see, I have two options, SNMP or Syslog however I would like to assign either Syslog or SNMP traffic via a specific port on the controller.


The reason is because i want to keep this traffic seperate to my wireless network.


My knowledge of controllers (and syslog and SNMP for that matter) but I can enter IP addresses for the servers however i cannot see how to assign this traffic to a specific port.


Is this possible? If so how?



Many Thanks,
-c

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
John Cook Mon, 07/12/2010 - 07:16
User Badges:
  • Bronze, 100 points or more

The traps will be sent from the management interface on the controller, so if your connectivity from WLC to switch is a trunk and your wireless networks are being handed off to a seperate vlan from your management vlan, you should be in good shape.


-John

Actions

This Discussion