CUCM 7.1.3 and VG-224 installation

Answered Question
Jul 12th, 2010
User Badges:

I cannot seem to get my new VG-224 to register to CM.  Setting the VG-224 up as SCCP- I built the gateway in CM and configured the VG-224.  I can ping the IP address of the VG-224 but it does not register to CM.  Can post the VG-224 config if needed.


Any thoughts or direction?


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (4 ratings)
Loading.
Adrian Saavedra Mon, 07/12/2010 - 15:11
User Badges:
  • Gold, 750 points or more

If configuration is 100% correct (CM and VG224), you can try:


vg224(config)#no sccp

vg224(config)#sccp

vg224(config)#no stcapp

vg224(config)#stcapp



Hope it helps, please rate if it does.


Kind regards,


- Adrian.

Correct Answer
William Bell Mon, 07/12/2010 - 15:38
User Badges:
  • Purple, 4500 points or more
Les Pruden Tue, 07/13/2010 - 07:23
User Badges:

Thanks for getting back to me -


Turned out that I missed the stcapp command after the command stcapp ccm-group 1

stcapp ccm-group 1
stcapp  <------------missed this


So - I didn't have the VG-224 programed correctly after all.  Once I entered that the Vg-224 registered right away.


Regards,

Les

Actions

This Discussion