cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1996
Views
0
Helpful
2
Replies

Cisco 7971 wont stay up!

ntong
Level 1
Level 1

Hello, I have an office full of 7971 phones and there are a few that no longer stand up.

The stand at the back is working OK, it sounds like a ratchet or something inside the phone is broken and moving around.... The stand just flops around.

Is there any way to fix this without having to replace the whole phone?

Thanks,

Nathan

1 Accepted Solution

Accepted Solutions

William Bell
VIP Alumni
VIP Alumni

An interesting solution to a similar problem:

https://supportforums.cisco.com/message/3062567#3062567

HTH.

Regards,

Bill

On 7/12/10 11:23 PM, "ntong@fbrice.com.au"

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

View solution in original post

2 Replies 2

William Bell
VIP Alumni
VIP Alumni

An interesting solution to a similar problem:

https://supportforums.cisco.com/message/3062567#3062567

HTH.

Regards,

Bill

On 7/12/10 11:23 PM, "ntong@fbrice.com.au"

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Hello, looks like I will have to do similar...

I dont need it to go up and down.... just to stay in place. Willl open up the phone and see if I can wedge something in there to keep it up.

Thanks for the link.

!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: