My NAM is no capturing anymore

Unanswered Question
Jul 13th, 2010

Hi,

I have a Network Analysed Module in a switch, and strangly it is not capturing anymore. It´s meet the system requierment and it was working just fine 2 weeks ago, i have tried to clean up old capture, same issue. Error message i got is: "please check the NAM snmp to the switch", when i´m in the GUI in setup --> Switch parameters.

Does someone knows anything about this ?

Regards

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Average Rating: 0 (0 ratings)
ganeshh.iyer Wed, 07/14/2010 - 01:29

Hi,

I have a Network Analysed Module in a switch, and strangly it is not capturing anymore. It´s meet the system requierment and it was working just fine 2 weeks ago, i have tried to clean up old capture, same issue. Error message i got is: "please check the NAM snmp to the switch", when i´m in the GUI in setup --> Switch parameters.

Does someone knows anything about this ?

Regards

Hi,

Try to check the parameter Wrap when Full and try capture and is snmp configuration is configured reagrding the switch community string in NAM.

http://www.cisco.com/en/US/products/sw/cscowork/ps2803/products_tech_note09186a00800948b5.shtml#topic1

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

Actions

Login or Register to take actions

This Discussion

Posted July 13, 2010 at 8:14 AM
Stats:
Replies:1 Avg. Rating:
Views:545 Votes:0
Shares:0
Tags: snmp, nam, switch, capture
+

Related Content

Discussions Leaderboard