ACS 4.2 For Windows DB Replication

Unanswered Question
Jul 13th, 2010

Hi Folks.

I have a pair of ACS for windows 4,2 and we also have a few mappings (ACS Group --> AD Group)

The replication process was configured and it replicates all the seetings, but the Group Mappings.

Is this the way it's supposed to be or it should replicate the group mappings as well?

Best regards,

AL

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
robmillet Tue, 07/13/2010 - 17:30

I think it depends on what options you have selected under:

system / ACS Internal Database replication / replication components

You can set the send or receive options. One is 'user and group database' the next one is 'group database only'.

You also can't do NDGs and NAPs at the same time - has to be one or the other.

Ganesh Hariharan Wed, 07/14/2010 - 01:45

Hi Folks.

I have a pair of ACS for windows 4,2 and we also have a few mappings (ACS Group --> AD Group)

The replication process was configured and it replicates all the seetings, but the Group Mappings.

Is this the way it's supposed to be or it should replicate the group mappings as well?

Best regards,

AL

Hi ,

Rob is right selected parameter under replication tab will replicated to secondary ACS,check under system configuration--database replciation then the following paramters are selected for replication in Primary ACS.

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

Jatin Katyal Wed, 07/14/2010 - 02:27

The following items cannot be replicated:

IP pool definitions (for more information, see About IP Pools Server).

ACS certificate and private key files.

Unknown user group mapping configuration.

Dynamically-mapped users.

Settings on the ACS Service Management page in the System Configuration section.

RDBMS Synchronization settings.


User guide

http://www.ciscosystems.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.2/user/guide/SCAdv.html#wp756078


Regards,

Jatin


Do rate helpful posts-

Actions

This Discussion