i wanted to know can you tell me what commands would i use to remove a trunk from an interface.
I have to move a trunk from FA0/1 and place it on Gi0/1, i thought that i could just copy and paste
the config from FA0/6 which is an access port and it would take the config on the trunk interface.
But when i did a sh run it's still a trunk port.Gi0/1 took the config because the port didn't have any
previous config on it.Any help would be greatly appreciate and thanks in advance.
You can use the "no" form of the command to remove the trunk configuation. You need to configure "switchport mode access" to change it from trunk to access mode.
switchport mode access
no switchport trunk encapsulation dot1q
Hope this helps.