Hey Brandon,

Thanks a million for this. I had to tweak it slowly as I am using dial peers in Ireland.

I need to plug in the mobile links now and test.

thanks again,

Paul.

Hey Brandon,

I have the card up runnign and its handling calls as part of my hunting group though I am trying to configure two physical POTS ports on the FXo card to route all cell phone traffic when available. Below is the config I have added for the card and for the call treatment.

voice-port 0/2/0
trunk-group FXO_GROUP 5
connection plar 6001
caller-id enable
!
voice-port 0/2/1
trunk-group FXO_GROUP 6
connection plar 6001
caller-id enable
!
voice-port 0/2/2
trunk-group FXO_GROUP 7
connection plar 6001
caller-id enable
!
voice-port 0/2/3
trunk-group FXO_GROUP 8
connection plar 7099
caller-id enable
!
!
dial-peer voice 2000 pots
trunkgroup FXO_GROUP 9
destination-pattern 9T
!
dial-peer voice 2001 pots
trunkgroup FXO_GROUP 10
destination-pattern 999
prefix 999

Dial peer to direct cell Phone calls to the Prolinks.

dial-peer voice 3000 pots
destination-pattern 9086........
forward-digits all
port 0/2/2

dial-peer voice 3001 pots
destination-pattern 9087........
forward-digits all
port 0/2/2

dial-peer voice 3001 pots
destination-pattern 9085........
forward-digits all
port 0/2/2

dial-peer voice 3001 pots
destination-pattern 9083........
forward-digits all
port 0/2/2

dial-peer voice 3000 pots
destination-pattern 9086........
forward-digits all
port 0/2/3

dial-peer voice 3001 pots
destination-pattern 9087........
forward-digits all
port 0/2/3

dial-peer voice 3001 pots
destination-pattern 9085........
forward-digits all
port 0/2/3

dial-peer voice 3001 pots
destination-pattern 9083........
forward-digits all
port 0/2/3

Any ideas on this?

paul.

Please ignore the last post.

The Prolink was a GSM-BRI model and I am using my FXO Cards so I need to get a replacement unit.

I am happy enough that my config is ok.

Paul.