cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
480
Views
0
Helpful
4
Replies

PRA layer 3 problem on outgoing calls

David Wagner
Level 1
Level 1

Hi,

i've a 2811 voice-gateway in a location in poland.All inbound calls are fine - no problems. But i experiencing strange problems on outgoing calls: Some calls are OK - but almost all outgoing calls fail. In the debug, i get the "CALL_PROC" and the "ALERTING" (the called phone rings). But after that, my gateway sends a "DISCONNECT".

Jul 15 06:17:47.266: ISDN Se0/2/0:15 Q931: Applying typeplan for sw-type 0x12 is 0x1 0x1, Calling num 48717XXXXX
Jul 15 06:17:47.270: ISDN Se0/2/0:15 Q931: Sending SETUP  callref = 0x00A0 callID = 0x8021 switch = primary-net5 interface = User
Jul 15 06:17:47.270: ISDN Se0/2/0:15 Q931: TX -> SETUP pd = 8  callref = 0x00A0
        Sending Complete
        Bearer Capability i = 0x8090A3
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA18381
                Preferred, Channel 1
        Progress Ind i = 0x8183 - Origination address is non-ISDN
WRO-STADIUM-VG1#
        Calling Party Number i = 0x1181, '48717XXXXX'
                Plan:ISDN, Type:International
        Called Party Number i = 0x91, '49XXXXXXXXX'
                Plan:ISDN, Type:International
Jul 15 06:17:47.358: ISDN Se0/2/0:15 Q931: RX <- CALL_PROC pd = 8  callref = 0x80A0
        Channel ID i = 0xA98381
                Exclusive, Channel 1
WRO-STADIUM-VG1#
Jul 15 06:17:53.382: ISDN Se0/2/0:15 Q931: RX <- ALERTING pd = 8  callref = 0x80A0
WRO-STADIUM-VG1#
Jul 15 06:17:57.786: ISDN Se0/2/0:15 Q931: TX -> DISCONNECT pd = 8  callref = 0x00A0
        Cause i = 0x80BF - Service/option not available, unspecified
Jul 15 06:17:57.826: ISDN Se0/2/0:15 Q931: RX <- RELEASE pd = 8  callref = 0x80A0
        Cause i = 0x80BF - Service/option not available, unspecified
Jul 15 06:17:57.830: ISDN Se0/2/0:15 Q931: TX -> RELEASE_COMP pd = 8  callref = 0x00A0

4 Replies 4

paolo bevilacqua
Hall of Fame
Hall of Fame

Which exact IOS ?

12.4.24T

Update: Both, inbound and outbound calls have these problems...

Are you using CM? I remember some wrong setting there can cause that. Unfortunately, I don't remember which ones.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: