What will happen when I remove controllers from mobility groups?

Unanswered Question
Jul 15th, 2010

Hi,

I'm wondering what exactly will happen when I remove a controller from a mobility group?

1) Will it require a reboot? (I don't think so, nothing I've found says so)

2) Will it deauth/reauth the AP's connected (I don't think so, nothing I've found says so)

3) Will it do anything else goofy?

I have 2 RF groups spanning continents over low speed links. All that is transmitted over mobility groups is session data correct? Not usernames, not ??? What am I missing here? I'm banging my head against the wall because I can't figure out why someone would configure the system in this way.

Setup:

WLC 4404, WLC 2100's

WCS 5.2.148

11xx series AP's

Radius Auth for domain users

a few SSID's, one guest SSID, no DHCP on any of the controllers

Thanks in advance,

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode