15.1T H.323 Caller ID (CUCM 4.1)

Unanswered Question
Jul 16th, 2010


I have an H.323 gateway that I'm trying to get caller ID working correctly on.  I've got it working to where the number and name display while the phone is ringing but when the user picks up the phone only the name displays and the number is not there.

Anyone seen this before?  The origional issue was with the name not showing and I got that working with..

voice class h323 1
h225 timeout ntf 300
h225 display-ie ccm-compatible


interface Serial0/0/1:23
isdn supp-service name calling

Thanks in advance for your help.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
mike-greene Fri, 07/16/2010 - 09:59

OK.  I figured the person I talked to was giving me incorrect information.

Disreguard the issue above.  The problem is when the call comes in, the number shows briefly and then it's replaced with the name only.  The customer wants to see two lines in the caller ID...name on top and number below.

This worked with MGCP but after there 323 migration it's stopped.  Any ideas?




This Discussion