cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1943
Views
0
Helpful
1
Replies

1250 LWAPP TO AUTONOMOUS

jcomment
Level 1
Level 1

Hi,

I can't seem to find the image for upgrading a 1250 from LWAPP to Autonomous?

Also do I need the upgrade tool? If so where can I find it? (No Controller)

Please can someone point me in the right direction?

Many Thanks.

1 Accepted Solution

Accepted Solutions

Kayle Miller
Level 7
Level 7

jcomment,

     There is an IOS image for the 1250 series AP on cisco's site, you must have a CCO account to access this. If you have access to that goto www.cisco.com, click on support> Download Software> Wireless> Access Points> Cisco Aironet 1250 Series> Cisco Aironet 1250 Series Access Point

then select IOS Software and you should get a list of versions.

In terms of converting this the easiest way is to use the mode button and do a reset.

Step 1 set your computer to 10.0.0.100 255.255.255.0

Step 2 Place image file into a TFTP server folder on your PC.

Step 3 Rename the access point image file in the TFTP server folder to c1250-k9w7-tar.default.

Step 4 Using an ethernet cable connect your PC to the power injector/AP

Step 5 Disconnect power from the access point.

Step 6 Press and hold the MODE button while you reconnect power to the access point.

Step 7 Hold the MODE button until the Radio LED turns a red color (approximately 20 to 30 seconds), and release the MODE button.

Step 8 it will download the firmware image and decompress it.

Step 9 After the access point reboots, you must reconfigure the access point by using the Web interface, the Telnet interface, or Cisco IOS commands.

Hope this helps....   Please rate helpful posts.

Thanks,

Kayle

View solution in original post

1 Reply 1

Kayle Miller
Level 7
Level 7

jcomment,

     There is an IOS image for the 1250 series AP on cisco's site, you must have a CCO account to access this. If you have access to that goto www.cisco.com, click on support> Download Software> Wireless> Access Points> Cisco Aironet 1250 Series> Cisco Aironet 1250 Series Access Point

then select IOS Software and you should get a list of versions.

In terms of converting this the easiest way is to use the mode button and do a reset.

Step 1 set your computer to 10.0.0.100 255.255.255.0

Step 2 Place image file into a TFTP server folder on your PC.

Step 3 Rename the access point image file in the TFTP server folder to c1250-k9w7-tar.default.

Step 4 Using an ethernet cable connect your PC to the power injector/AP

Step 5 Disconnect power from the access point.

Step 6 Press and hold the MODE button while you reconnect power to the access point.

Step 7 Hold the MODE button until the Radio LED turns a red color (approximately 20 to 30 seconds), and release the MODE button.

Step 8 it will download the firmware image and decompress it.

Step 9 After the access point reboots, you must reconfigure the access point by using the Web interface, the Telnet interface, or Cisco IOS commands.

Hope this helps....   Please rate helpful posts.

Thanks,

Kayle

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: