SPA941 Dialplan

Unanswered Question
Jul 18th, 2010

I have a freeswitch server and it is up and running  - serving a softphone successfully.  I tried to connect a linksys spa941 and it just always "fast busy" signals me when I try to dial.  The phone is connected and registered to the freeswitch server - sso I think I have a dialplan issue.

Anyone have experience with this - and what the dialplan should be?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
CTRLITINC Tue, 07/20/2010 - 10:57

Shawn,

This really depends on your enviornment and local. The phone has a dial plan as does the PBX.

It would be best to consult the following and go from there:

http://www.cisco.com/en/US/docs/voice_ip_comm/csbpipp/ip_phones/administration/guide/spa500_admin.pdf

Page 174 - Configuring Dial Plans

I realize this is for the SPA500 IP Phones, but the SPA941 I believe to use the same Dial Plan, but this is the best explanation I have found for configuring dial plans. Here is another resource you might find helpful:

https://supportforums.cisco.com/docs/DOC-9953

This is for Asterisk, but should be similar for any SIP-compliant device and will show you how to configure your phone manually since you are not using a Cisco PBX, where it configures it automatically.

HTH,

Steve Wofford

Call Ctrl Call Manager for

SPA900 - SPA500 IP Phones

Actions

This Discussion