Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1562
Views
0
Helpful
1
Replies

SPA941 Dialplan

shawnbure
Level 1
Level 1

‎07-18-2010 01:27 PM - edited ‎03-21-2019 02:47 AM

I have a freeswitch server and it is up and running  - serving a softphone successfully.  I tried to connect a linksys spa941 and it just always "fast busy" signals me when I try to dial.  The phone is connected and registered to the freeswitch server - sso I think I have a dialplan issue.

Anyone have experience with this - and what the dialplan should be?

Labels:
0 Helpful
1 Reply 1

CTRLITINC
Level 1
Level 1

‎07-20-2010 10:57 AM

Shawn,

This really depends on your enviornment and local. The phone has a dial plan as does the PBX.

It would be best to consult the following and go from there:

http://www.cisco.com/en/US/docs/voice_ip_comm/csbpipp/ip_phones/administration/guide/spa500_admin.pdf

Page 174 - Configuring Dial Plans

I realize this is for the SPA500 IP Phones, but the SPA941 I believe to use the same Dial Plan, but this is the best explanation I have found for configuring dial plans. Here is another resource you might find helpful:

https://supportforums.cisco.com/docs/DOC-9953

This is for Asterisk, but should be similar for any SIP-compliant device and will show you how to configure your phone manually since you are not using a Cisco PBX, where it configures it automatically.

HTH,

Steve Wofford

Call Ctrl Call Manager for

SPA900 - SPA500 IP Phones

0 Helpful
Customers Also Viewed These Support Documents