Problem NAT'ing on a WAN link on a 2811

Unanswered Question
Jul 19th, 2010
User Badges:

Like so many posts let me start off by saying I am new to configuring routers.  My configuration is a hub with three spokes.  The configuration i am attaching is one of the spokes.  On the outside of this spoke they will not let me use my IP's that I have configured at the hub and the other two spokes, so I have to NAT all of my IP's that I need to target.  I am having issues around getting the NAT configuration right to pass my traffic.  In the past I have only done NAT on firewalls and this configuration I am forced to do it on my router.

Here is an example:


If I need to target say 192.168.100.20 on one of the spokes they told me I have to target 161.231.134.185 and NAT it on my interface to the 192.168.100.20.


I have attached my config for this spoke that I am doing the NAT's on.  Please if anyone can help me out that would be great.


I have modified my IP scheme and keys in the attached config just for security.


The tunnel comes up and I can pass traffic between the serial interfaces.....just getting the NAT'd traffic to pass doesnt seem to work.


Thank you,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content