Syslog missing # packets

Answered Question
Jul 19th, 2010
User Badges:
  • Bronze, 100 points or more

I seem to be missing some settings.

I need ALL syslog messages generated by two border routers but cannot get passed the missed packet status messages:

access-list logging rate-limited or missed 23 packets

I do receive most mesages but periodiucally receive the rate-limited or missed # packet mesage.

These two routers are consistently running at 2% utuilization, NEVER higher than 3%. I never receive more than 50 mesages per second

This is the config related to the logging on each of the 2 routers:

logging userinfo
logging queue-limit trap 200
logging buffered 32768
logging rate-limit 10000
logging history size 500
logging origin-id hostname
logging facility local6

I tried turing off the logging rate-limit 10000 command with the no logging rate-limit but this did not help either.

Router is a Cisco 2821 running c2800nm-advipservicesk9-mz.124-15.T9.bin IOS.

Thank you for ANY assistance!


Correct Answer by Chetan Kumar Ress about 6 years 9 months ago


Please refer the below link.

The below link will help to userstand access control list logging .


Chetan Kumar

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)


This Discussion