Cannot Access GUI in WLC

Unanswered Question
Jul 19th, 2010
User Badges:

Hello,


I have two WLC4404  with version 6.x in the same VLAN, same mobility group, same SSID, same interfaces, of course, with different IP Address, just the Virtual IP Address is the same in both devices. Well, I cannot access via GUI the second WLC, but when I turn off the first WLC1, then I can access second WLC.


If both of them are connected, I just can access WLC1, but not WLC2.


Any ideas?


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
dancampb Tue, 07/20/2010 - 06:41
User Badges:
  • Cisco Employee,

Is the PC you are using to access the controller's GUI attached to the network wirelessly?  You may have to enable management via dynamic and access the second controller through its dynamic interface.

moises.rodriguez Tue, 07/20/2010 - 07:48
User Badges:

I forgot to say that Mgmt via wireless is enabled on both controllers, also, the same thing happens

when you try to reach the controller vi ethernet cable.

Actions

This Discussion

Related Content

 

 

Trending Topics - Security & Network