CP-7911G Wall Plate Mount

Unanswered Question
Jul 20th, 2010

I am trying to mount a 7911 phone to the wall using a standard wall plat.  Apparently the holes do not line up.  Does anyone know of a wall plate in which the 7911 can mount flat on the wall?

The Cisco locking wall bracket is not good for my application and since it tilts the phone up.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
rob.huffman Tue, 07/20/2010 - 13:32

Hi Michael,

The spacing of the Back-side mounting holes enables direct mounting

to the Electrical box, no Mounting plate is required



blackmichael Tue, 07/20/2010 - 15:36

Is there a specific screws to use for the best fist?

Also is there a plate i can use to mount the RJ45 port behind the phone so its not an empty electrical box.

rob.huffman Wed, 07/21/2010 - 06:08

Hi Michael,

The mounting holes are pretty forgiving and will work with

a number of Screws. We found the "best" fit was to use

a 1mm x 1mm (round head Phillips)

I have not seen a Mounting plate that would work within an

electrical box We are an "Amp" cabling infrastructure

shop, so a Part# like the following worked well within the

box ;





This Discussion

Related Content