no audio because of nat

Unanswered Question
Jul 20th, 2010
User Badges:



I am trying to set up my router and I have it at the point where I can call my phones but I get no audio. When I run my sniffer I see sip and register messages but I do not see any rtp from behind my router.  I am trying to send voice traffic to s0/1 and data to s0/0.  It looks like a nat issue but I can not put my finger on it.


Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chester Rieman Mon, 08/02/2010 - 10:04
User Badges:
  • Cisco Employee,

What device is doing NTA?  I has to be aware of and perform the translations for RTP as learned from the signaling protocol.

For example, if a PIX were doing the NAT and the signaling was done via H323, the fixup protocol h323 command would enable this.



Hope this helps....

Actions

This Discussion