07-21-2010 02:33 AM - edited 03-04-2019 09:08 AM
Hi,
I have a strange behaviour from one of the 2921 routers that I work with.
This router reboot when each time I save the running config to the startup config.
The router reboot as well when I save the running config on to the other router it is connected to for failover purpose (ipsec stateful failover).
The two routers have the same config except for the IP addresses and one of them is not rebooting when I save the running config but the other one does.
I would be happy of any suggestion on how to solve this issue.
Thanks in advance.
07-21-2010 08:18 PM
TAC case.
If router is brand new, you should be able to open a case even without a support contract.
07-22-2010 01:20 AM
Thank you very much for your answer.
I will open a case the Cisco TAC and will update this thread.
08-06-2010 07:10 AM
Hi,
I have contacted the Cisco TAC and they advised me that is was a known issue with IOS 15.0(1r)M1 and advised me to upgrade the IOS version
to 15.1(2)T or to wait for the next Mainline train release. The 15.1(2)T contain a fix for this issue.
I have installed the 15.1(2)T firmware and it seem to have solved the issue.
I am currently monitoring and testing with this new firmware.
Thanks again for your answer on this issue.
Best regards,
AEK
08-06-2010 09:51 AM
Please report bug id if you know it.
08-09-2010 01:52 AM
Hi,
The bug number is CSCte62190.
Best regards,
AEK
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: