07-21-2010 07:05 AM - edited 02-21-2020 04:01 AM
How do you access the standby firewall in a HA availability setup ? In other words, Is there a way to connect to the backup unit so that I can run the enable command and then do a "show tech-support" which will give the serial number?
07-21-2010 07:09 AM
Definitely can.
If you haven't already configured the standby ip address, you would need to configure the standby ip address on the Active ASA.
Example:
interface g0/1
nameif inside
ip address 10.1.1.1 255.255.255.0 standby 10.1.1.2
Once the above has been configured for each interface, you can access the standby ip address for the standby ASA. In the above case, it's 10.1.1.2.
Hope that helps.
07-21-2010 07:14 AM
I agree that you can access the ASA via the standby address but if i am thinking this thru properly that will only allow me access to the firewall that is currently the primary firewall.
What i am trying to do is to access the ASA that is the slave/standby etc without failing over to it. Thoughts?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: