cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
603
Views
0
Helpful
3
Replies

Allways device out-of-sync

mmisonne
Level 2
Level 2

Hello

I allways have out-of-sync device.

I Have LMS3.2  with RME 4.3.1

Although, I configured "exclude command" with "ntp-clock priod .certificate. and so on." for the dev category "switch and hub".

But  when I click "out of sync" it allways shows me the device ( SW 2950..SW3560 .) with difference  like ntp-clock.

This happens also after a new config ftech.

Can you help me .

Rgards

Michel Misonne

3 Replies 3

Joe Clarke
Cisco Employee
Cisco Employee

Post a screenshot showing the diffs as RME sees them.

Hello Jo

Here is my screenshot.

I noticed also that the device which are allways out-of-sync are 3560V2.

If I checked the device pakage , I have the package "Cat3560" ver 7.1

Rgds

Michel

Hello again

Finaly,I made a Device Update  for all RME device, and it works fine now.

Regrads

Michel

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco