UCCX 7.01 hangs after "Please wait while System Parameters are saved"

Unanswered Question
Jul 21st, 2010

Have a new system, here is the order in which I completed the steps:

OS disk

OS Patches

installed CRS

Installed SQL

installed SR5

OS patches again

initial config

When going through the initial configuration I get to enter the information for HR Sessions and Codec and it tells me "Please wait while System Parameters are saved".  After a few minutes it refreshes to a blank page and the system is not configured.

Any suggestions would be appreciated.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ahochau_2 Thu, 07/22/2010 - 11:42

Rebuilt the damned thing and started from Scratch.  (Need to add to the release notes “UCCX server must be rebuilt a minimum of 3 times” as it seems this always happens.)  After this things are happy.  I did see a differnent set of screens during the initial configuration but wasn't smart enough to document them.

1.       Installed OS

2.       Installed UCCX 7.01

3.       Installed SQL for UCCX 7

4.       Ran Initial Configuration

5.       Installed SR5 for UCCX 7

6.       Installed OS updates 3002.1.5aSR9


This Discussion

Related Content