Hot stand by and cold stand by

Unanswered Question
Jul 21st, 2010
User Badges:

Hi

can I ask what is difference bewteen hotstandby and coldstandby in supervisor module


1   Standby Supervisor  RPR                 Standby cold
2   Active Supervisor   RPR                 Active


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Reza Sharifi Wed, 07/21/2010 - 20:05
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

Hi,


When RPR mode is used, the standby supervisor engine partially boots and keeps synchronized copies of the active configuration, which shortens the time needed to bring up the standby supervisor engine and have it start handling traffic from 1.5 minutes (for a cold boot on the standby) to 30 seconds (to finish the boot and re establish links). Hot standby applies to SSO mode.  If possible use SSO instead of RPR.


HTH

Reza

Actions

This Discussion