Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
557
Views
0
Helpful
1
Replies

slm and CISCO catalyst

ciscocips
Level 1
Level 1

‎07-22-2010 12:51 PM - edited ‎03-06-2019 12:09 PM

Hello gurus.

I need to create a 802.1q trunk between a CISCO Catalyst and a CISCO SLM224G switch.

No problem for the IOS switch, but I don't have clear how should I create a trunk with the web interface of the SLM224. The docs are not explaining anything on this.

Anyone of you can help? Thanks so much....

Cips

Labels:
0 Helpful
1 Reply 1

Reza Sharifi
Hall of Fame
Hall of Fame

‎07-22-2010 01:13 PM

Hi Cips,

According to the admin guide it is under vlan management>port setting> then click on acceptable frame type then you see tagged or untagged.

Here is the admin guide:

http://www.cisco.com/en/US/docs/switches/lan/csbss/slm2024/administration/guide/SLM_Admin_Guide_Publish.pdf

Good luck

Reza

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card