07-26-2010 02:42 AM - edited 03-15-2019 11:54 PM
Hi All,
I managed to establish E1 CAS connection between Cisco 2800 series router & a 3th party TDM IVR.
With the following commands,
controller E1 0/1/0
framing NO-CRC4
clock source line primary
ds0-group 1 timeslots 1 type fxo-loop-start
ds0-group 2 timeslots 2 type fxo-loop-start
And tried to do the same thing with a AS5400 XM but unfortunatelly “fxo-loop-start” is not supported in AS 5400XM
(config-controller)#ds0-group 0 timeslots 1 type ?
e&m-fgb E & M Type II FGB
e&m-fgd E & M Type II FGD
e&m-immediate-start E & M Immediate Start
fxs-ground-start FXS Ground Start
fxs-loop-start FXS Loop Start
none Null Signalling for External Call Control
p7 P7 Switch
r2-analog R2 ITU Q411
r2-digital R2 ITU Q421
r2-lsv181-digital R2 LSV 181
r2-pulse R2 ITU Supplement 7
sas-ground-start SAS Ground Start
sas-loop-start SAS Loop Start
Which one should i use instead of “ fxo-loop-start “
Thanks for your help.
07-26-2010 03:57 AM
Hi
Have you tried type "R2-digital" for CAS E1 in AS5400XM ? Pl check
Regards
Lavanya
07-26-2010 04:00 AM
Yes i tried it but did not work.
07-26-2010 05:52 AM
Must be E1 R2.
Nobody uses "pure" E1 CAS.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: