07-27-2010 11:01 AM - edited 07-03-2021 07:01 PM
lap 1252 is shown in CDP but not associated with wlc 2112 software version 5.1
Solved! Go to Solution.
08-02-2010 02:43 PM
Ok. On the AP, do a "dir" command. You should see two IOS in the list. One of the IOS has the "rcv" between the filename. If you see this then DELETE the second/third IOS using the command "delete /f /r flash:
Hope this helps.
07-27-2010 02:56 PM
Could you, by any chance, provide further information?
1. Is this happening to just one AP or all?
2. What is the full IOS version your AP is running?
3. Is the AP connected to an access port?
4. Is your WLC connected to an access port?
5. What error message do you get?
6. Is the LAP getting a valid IP address?
Alternatively, console into the AP and enter the command "lwapp ap controller ip address
Please don't forget to rate useful posts. Thanks.
07-30-2010 02:24 AM
Hi leolaohoo
Thanks for quick reply
1. Is this happening to just one AP or all? All ap
2. What is the full IOS version your AP is running? 12.4
3. Is the AP connected to an access port? One ap is Directly connected to WLC port no-3 and another ap is in Trunk port (there are Nortel switches)
4. Is your WLC connected to an access port? Trunk Port
5. What error message do you get?
6. Is the LAP getting a valid IP address? No ap is not getting IP when I am trying to configure controller ip then getting error msz - Command disabled
I am unable to reset ap also
Description: cid:image001.png@01CB2E60.16D05040
Thanks & Regards,
Vikram Singh
08-01-2010 07:20 PM
No ap is not getting IP when I am trying to configure controller ip then getting error msz - Command disabled
This is the reason why your AP is not joining. It's because the AP can't get a valid IP address. You can't, with 5.X firmware, configure the IP address of the AP using this method. You have to use the command "lwapp ap ip address
Please don't forget to rate useful posts. Thanks.
PS: Cisco is recommending everyone to avoid 5.X like a bad smell. Upgrade to 7.X instead.
08-02-2010 01:49 AM
I have Tried lwapp ap ip address
command disabled
08-02-2010 02:43 PM
Ok. On the AP, do a "dir" command. You should see two IOS in the list. One of the IOS has the "rcv" between the filename. If you see this then DELETE the second/third IOS using the command "delete /f /r flash:
Hope this helps.
08-19-2010 04:02 AM
Thanks
I have upgrade the WLC IOS
All problem has been resolved
08-19-2010 05:24 PM
Thanks for the ratings. Again, please stay away from 5.X and 6.X firmware. Upgrade to 7.X if you can.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: