Javier Henderson Wed, 07/28/2010 - 13:49

Log into the CLI, then do "show run" to see the current config, then go into "config t" (as you would on an IOS device) and make the changes as needed.

Jason Aarons Wed, 07/28/2010 - 13:52

Cool . That worked. Wonder why you can't setup network settings from the GUI.

Config t

Ip name-server x.x.x.x


Wr mem

Javier Henderson Wed, 07/28/2010 - 13:55

Because the GUI controls the application (ACS) and the change you wanted to make was to the operating system.


This Discussion