07-30-2010 11:24 AM - edited 03-21-2019 02:49 AM
Specifically a Bogen TPU-100? If so is an adapter needed between the UC500 and the paging system?
07-30-2010 12:40 PM
You can definitely interface an external paging system with the UC500. I believe with this Bogen, you'll need a telephonye access module (Bogen TAMB). You can then use either an FXS or FXO port to connect to the TAMP.
http://www.bogen.com/products/pdfs/telephonepagepdfs/TAMBs.pdf
Hope this helps.
Brandon
07-30-2010 11:49 PM
Hi all
There is a Video on demand at the following location, exactly on this topic.
https://supportforums.cisco.com/docs/DOC-10460
I actually hooked a FXS connected Valcom single zone overhead paging system up as well as a Cyberdata multicast paging system during the technical even i ran.
Check it out.
regards Dave
08-02-2010 09:30 AM
Thank you Dave!
08-02-2010 09:47 AM
Thank you Brandon!
07-30-2010 03:17 PM
Hi Eric,
Bogen has a UTI1 device that connects to the TOU-100. You would use an FXS port to connect to the station port on the UTI1.
08-02-2010 09:34 AM
Thank you Mario!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide