You can change the * - Prefix for Speeddial to #;
2. configure terminal
3. stcapp feature speed-dial
4. digit number
5. prefix prefix-string
6. speed dial from digit to digit
7. redial keypad-character
8. voicemail keypad-character
| || |
Command or Action
Enables privileged EXEC mode.
•Enter your password if prompted.
Router# configure terminal
Enters global configuration mode.
stcapp feature speed-dial
Router(config)# stcapp feature speed-dial
Enables FSD codes and enters STC application feature speed-dial configuration mode to set speed-dial prefixes and codes.
Router(config-stcapp-fsd)# digit 2
(Optional) Sets the number of digits that are used for speed-dial codes.
•This command is supported in Cisco IOS Release 12.4(6)T and later releases.
•number—Number of digits to enter for speed-dial codes. Value is 1 or 2. Default is 1.
Note Modifying the value of this command resets the speed dial and voicemail commands to their defaults.
Router(config-stcapp-fsd)# prefix ##
(Optional) Sets a prefix string to indicate that the following keypad character is a speed-dial code.
•prefix-string—One to five characters that can be dialed on a phone keypad. Lead character must be an asterisk (*) or a number sign (#). Default is *.
speed dial from digit to digit
Router(config-stcapp-fsd)# speed dial from 2 to 7
(Optional) Sets the range of codes to use for dialing speed-dial numbers in ascending or descending order.
•digit—Starting and ending number for the range of speed-dial codes. Range is:
–0 to 9 for one-digit codes. Allows a maximum of nine speed-dial codes. This means that if you set the starting number to 0, the highest number you can set for the ending number is 8. Default is 1 to 9.
–00 to 99 for two-digit codes. Allows a maximum of 99 speed-dial codes. Default is 01 to 99.
Note Number of allowed digits depends on the value set with the digit command.
Router(config-stcapp-fsd)# redial 9
(Optional) Sets the code to use for redialing the last number dialed.
•keypad-character—String that can be dialed on a phone keypad. Default is #.
•In Cisco IOS Release 12.4(20)YA and earlier releases, this is a single character. Value: 0-9, #, or *.
•In Cisco IOS Release 12.4(20)YA and later releases, length of keypad-character is a single character or 2 digits (00-99).
•To configure the code so that the phone user is not required to dial the prefix to access this feature, length of keypad-character must be 2 to 4 characters and the leading or ending character must be an asterisk (*) or a number sign (#).
•In Cisco IOS 15.0(1)M and later releases, to configure the code so that the phone user is not required to dial the prefix or any special character to access this feature, length of keypad-character must be 3 or 4 digits (000-9999).
Router(config-stcapp-fsd)# voicemail 8
(Optional) Sets the code to use for dialing the voice-mail number that is defined in Cisco Unified Communications Manager or the Cisco Unified CME router.
•keypad-character—One or two digits that can be dialed on a telephone keypad. Default is 0 (zero) for single digits; 00 (two zeros) for two digits.
Note Number of digits allowed depends on the value set with the digit command.
Exits STC application feature speed-dial configuration mode and returns to privileged EXEC mode.