Hi everybody. I installed a brand new ASA to replace my current one, and need a bit of help with the setup of AnyConnect. I believe I have everything setup correctly, except for my NAT exceptions. I can successfully connect to the ASA via the clientless page and the AnyConnect client, but can't get past the ASA, so I'm assuming its NAT exceptions. I've been looking at both the ASA_cli.pdf but can't seem to nail it down. Even using the ASDM, which I normally don't do for VPN, its not spelled out as easy as asdm 6.1.
On my current ASA, I know that I have an ACL called NoNat. For reference, my internal networks are 10.0.x.x, and my ip pool for VPN users is 192.168.2.x.
Any help would be greatly appreciated. Thanks in advance
add DNS and WINS servers to the corresponding Anyconnect group-policy so that it is pushed to the clients when they connect. Also make sure the servers are reachable when connected via Anyconnect.