cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
438
Views
0
Helpful
4
Replies

pass traffic between ezvpn client routers, with pix ezvpn server

Acruzgreg
Level 1
Level 1

hello,

I have a problem, I´m  configuring ezvpn client in router 881 with pix 515 how ezvpn server, the vpn is established between pix and router, and I can ping the lan in the pix from the router ezvpn client, mi problem is that I can´t ping between 2 router 881 ezvpn clientsCaptura1.PNG

can you help me

regards

4 Replies 4

Yudong Wu
Level 7
Level 7

You can refer to the example in the link below.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00804675ac.shtml

Basically, your PIX need to run "7.x" so that you can use "same-security-traffic permit intra-interface".

If you still can not make it work, paste your configuration here.



also you might need the following

for 8.2.1 and earlier

static (outside,outside) norandom-seq nailed

static (outside,outside) noramdom-seq nailed

failover timeout -1

for 8.2.2 and later configure tcp state bypass

hello,

tanks for your response, in the router 881 I have a link ADSL

this is the configuration of the device that I configured

regards

PIX 6.3 does not support U-turn traffic, you can not send the packet out on the same interface where it is received.

You have to upgrade to code to 7.x first.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: