New switch IOS/Config upgrade issues

Unanswered Question
Aug 3rd, 2010
User Badges:

This is a very basic question.


I have configured a 3560, vlan 1 with an IP address of 10.10.10.1, set fa0/1 to access vlan 1


I have set my laptop up with IP address 10.10.10.10, default gateway 10.10.10.1.


From the laptop I can PING and Telnet into the switch, however, from the switch I cannot PING or open up a TFTP session with the TFP server running on the laptop


I configured fa0/1 as:


switchport

switchport mode access

switchport access vlan 1

no shut




However, if I do a show run, there is only one line listed:


Interface Fa0/1

switchport mode access





Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Jayakrishna Mada Tue, 08/03/2010 - 10:06
User Badges:
  • Cisco Employee,

Hi,



The switchports are by default in vlan 1, so the command "switchport access vlan 1" is/was already in there, hence you don't see the command when you do a show run on the interface.


Check the firewall on the PC. I am pretty sure its the Windows firewall or other firewall blocking it. Disable that and it should start working.


JayaKrishna

Actions

This Discussion