cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
362
Views
5
Helpful
2
Replies

New switch IOS/Config upgrade issues

gginty
Level 1
Level 1

This is a very basic question.

I have configured a 3560, vlan 1 with an IP address of 10.10.10.1, set fa0/1 to access vlan 1

I have set my laptop up with IP address 10.10.10.10, default gateway 10.10.10.1.

From the laptop I can PING and Telnet into the switch, however, from the switch I cannot PING or open up a TFTP session with the TFP server running on the laptop

I configured fa0/1 as:

switchport

switchport mode access

switchport access vlan 1

no shut

However, if I do a show run, there is only one line listed:

Interface Fa0/1

switchport mode access

Thanks

2 Replies 2

Jayakrishna Mada
Cisco Employee
Cisco Employee

Hi,

The switchports are by default in vlan 1, so the command "switchport access vlan 1" is/was already in there, hence you don't see the command when you do a show run on the interface.

Check the firewall on the PC. I am pretty sure its the Windows firewall or other firewall blocking it. Disable that and it should start working.

JayaKrishna

Fixed thanks...  Firewall

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: