Magnus Mortensen Tue, 08/03/2010 - 20:32
User Badges:
  • Cisco Employee,

"failover lan" is used to configure the basic failover configuration sync. "failover link" is for the stateful 'link' which exchanges state table info lile connections, etc.   - Magnus

Gagandeep Kumar Tue, 01/07/2014 - 04:02
User Badges:

Hello,


So which one should be used? Or if I want to enable statefull failover so that when my Primary firewall goes down, all the connection information should be passed to secondary set and secondary to act as active one. For this do  I need to enable both Lan failover as well as link faiolver?


Or is it if failover link only helps in sharing connection information to secondary firewall?

Actions

This Discussion