08-04-2010 05:56 AM - edited 03-06-2019 12:18 PM
Hi All,
I try to combine two uplinks from two 3750G stack switches into one etherchannel connected to another two stack switches which has one etherchannel too. If the master switch fail, then one link in the etherchannel goes down. I think the etherchannel should have no outage with this master failure, right?
Thanks a lot for the help!
Lou
Solved! Go to Solution.
08-04-2010 06:06 AM
Hello,
3750 platform supports cross-stack etherchannel. In other words, the whole
stack is treated as one switch. So, if the master goes down, only ports on
the master go down and the etherchannel stays up. The slave inherits all the
masters configurations and continues to operate normally.
Hope this helps.
Regards,
NT
08-04-2010 06:06 AM
Hello,
3750 platform supports cross-stack etherchannel. In other words, the whole
stack is treated as one switch. So, if the master goes down, only ports on
the master go down and the etherchannel stays up. The slave inherits all the
masters configurations and continues to operate normally.
Hope this helps.
Regards,
NT
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: