cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1366
Views
0
Helpful
2
Replies

UCS 200 M2 HDD driver for VMWare 4.0

gowgovin
Cisco Employee
Cisco Employee

UCS C200 M2 is not detecting hard disk controller(lsi megaraid 9260-4i ) in VMware ESX 4.0. I appreciate, if you can share the driver location.

Thanks

Gowdaman

2 Replies 2

Jason Aarons
Level 6
Level 6

At boot time did you hit Control H to go into the LSI MegaRaid utility and run the Configuration Wizard and setup your Virtual Drives (RAID 1, Boot) ? After you do that you need to go into the BIOS and set the Boot Order #1 to BUS 0E Dev 00 PCI ?? Else it won't boot off that disk once you do get ESXi installed.

Daniel Laden
Level 4
Level 4

You mention that you have ESX 4.0.  Reviewing the Hardware and Software Interoperability Matrix document, the minimum release is 4.0 Update 1.  You may have already known this but just covering the bases.

Hardware and Software Interoperability Matrix

http://www.cisco.com/en/US/docs/unified_computing/ucs/interoperability/matrix/r_hcl_C_rel1.31.pdf

C200 M2
LSI
MegaRAID
9260-4i
vSphere 4.0U1

Thank You,

Dan Laden

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: