OSPF Stub Area setup

Answered Question
Aug 7th, 2010
User Badges:

I'm setting up a stub area with 2 routers over a switch. I'm having a  problem with getting the adjacency through the switch, but I get it if I  use a crossover cable.


Besides the ports being active on the switch is there any other configuration that I need? i.e. a VLAN?


Thanks

Correct Answer by Nagaraja Thanthry about 6 years 8 months ago

Hello,


Please make sure that both ports where you have connected the routers are on

the same VLAN (same broadcast domain). Also, make sure that the switch

supports multicast traffic.


Hope this helps.


Regards,


NT

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Nagaraja Thanthry Sat, 08/07/2010 - 15:10
User Badges:
  • Cisco Employee,

Hello,


Please make sure that both ports where you have connected the routers are on

the same VLAN (same broadcast domain). Also, make sure that the switch

supports multicast traffic.


Hope this helps.


Regards,


NT

Actions

This Discussion