08-08-2010 02:57 AM
How can be Disable the Hold Key feature from Cisco IP Phone 7970 Model .
Solved! Go to Solution.
08-08-2010 02:20 PM
Hi
You can try creating a new softkey set and assigning it to the phones.. assuming a linux CCM:
- First go to Device/Device Settings/Softkey Template
- Copy the current softkey set, give it a new name and save it
- Towards the top right there is a 'Configure Softkey Layout' link; hit 'Go' on that
- Select the 'Connected' state, then move the 'Hold' key out of the 'Selected' softkey box
- You may want to do the same for the other 'Connected...' states
Then assign that template to the phones.
Regards
Aaron
Please rate helpful posts...
08-08-2010 02:20 PM
Hi
You can try creating a new softkey set and assigning it to the phones.. assuming a linux CCM:
- First go to Device/Device Settings/Softkey Template
- Copy the current softkey set, give it a new name and save it
- Towards the top right there is a 'Configure Softkey Layout' link; hit 'Go' on that
- Select the 'Connected' state, then move the 'Hold' key out of the 'Selected' softkey box
- You may want to do the same for the other 'Connected...' states
Then assign that template to the phones.
Regards
Aaron
Please rate helpful posts...
08-09-2010 12:36 AM
Hi
Aaron
Thanks for your feedback, its Helps for me .
I am high appreciated.
Regards
Syed Akbar Ali
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: