08-08-2010 07:12 AM - edited 03-16-2019 12:08 AM
Hi there
I finally setup unity to call a number for notification.
It calls correct and the prompts for the ID (please enter your ID or press "1" to disable notifications on this line), but no matter what I enter (tried PIN with and without # or directory number), it continious asks for the ID and hangs up after a while.
Am I missing something?
Thanks
Andre
Solved! Go to Solution.
08-08-2010 07:51 AM
Hi Andre,
Sounds like DTMF may not be making it to Unity. Take a quick look at this document explaining a dial-peer configuration that you may need to adjust on your GW:
http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_tech_note09186a0080094607.shtml
Hope that helps,
Brad
08-08-2010 07:51 AM
Hi Andre,
Sounds like DTMF may not be making it to Unity. Take a quick look at this document explaining a dial-peer configuration that you may need to adjust on your GW:
http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_tech_note09186a0080094607.shtml
Hope that helps,
Brad
08-08-2010 08:07 AM
that did it.
Thanks a lot
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: