08-08-2010 10:13 PM - edited 03-19-2019 01:22 AM
dear any body
can any body assist me how to connect third party sip soft phones with call manager 7.0 becouse i have a soft phone instaled in my iphone and its not configuring with cucm7 manager so please try to send me an step by step config for this issue.
with regards
08-08-2010 11:11 PM
HI,
Below you can find step by step SIP phone configurations.
Configure Cisco SIP Phone
Use these steps to verify that you successfully configured a Cisco SIP phone on Cisco CallManager 5.0.
Solution
For a successful completion for Task "1", your screens for this lab should look like the following pictures:
Choosing SIP as device protocol during device configuration:
Create a dummy SIP Phone:
Task 2: Configure 3rd Party SIP Phone
Use these steps to verify that you successfully configured a third party SIP phone on Cisco CallManager 5.0..
Solution
For a successful completion for Task "2", your screens for this lab should look like the following pictures:
Configure End User for 3rd Party SIP Phone:
Configure 3rd Party SIP Phone in CallManager:
X-Lite configuration on PC Phone1-1:
Regards,
Muhammad Amir Raza
08-09-2010 10:52 AM
Here are a few step-by-step's...the client software is of no consequence. Just follow the steps to set up the Basic 3rd-Party SIP phone.
http://www.netcraftsmen.net/resources/blogs/sip-endpoints-in-cisco-cucm-x-lite-as-an-example.html
The second blog above is specifically related to 2 iPhone clients.
And just in case you're interested, here's an example for CME as well:
Hailey
Please rate helpful posts!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: