08-08-2010 10:13 PM - edited 03-19-2019 01:22 AM
dear any body
can any body assist me how to connect third party sip soft phones with call manager 7.0 becouse i have a soft phone instaled in my iphone and its not configuring with cucm7 manager so please try to send me an step by step config for this issue.
with regards
08-08-2010 11:11 PM
HI,
Below you can find step by step SIP phone configurations.
Configure Cisco SIP Phone
Use these steps to verify that you successfully configured a Cisco SIP phone on Cisco CallManager 5.0.
Solution
For a successful completion for Task "1", your screens for this lab should look like the following pictures:
Choosing SIP as device protocol during device configuration:
Create a dummy SIP Phone:
Task 2: Configure 3rd Party SIP Phone
Use these steps to verify that you successfully configured a third party SIP phone on Cisco CallManager 5.0..
Solution
For a successful completion for Task "2", your screens for this lab should look like the following pictures:
Configure End User for 3rd Party SIP Phone:
Configure 3rd Party SIP Phone in CallManager:
X-Lite configuration on PC Phone1-1:
Regards,
Muhammad Amir Raza
08-09-2010 10:52 AM
Here are a few step-by-step's...the client software is of no consequence. Just follow the steps to set up the Basic 3rd-Party SIP phone.
http://www.netcraftsmen.net/resources/blogs/sip-endpoints-in-cisco-cucm-x-lite-as-an-example.html
The second blog above is specifically related to 2 iPhone clients.
And just in case you're interested, here's an example for CME as well:
Hailey
Please rate helpful posts!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide