cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1215
Views
0
Helpful
3
Replies

IDSM-2 with VSS system

asabagh
Level 1
Level 1

Hi,

We are looking forward to install a Cisco 6513 with IDSM-2 in each chassis in a VSS mode. Does anyone have an experience with the configuration of the 6513 ?  Also, lets assume I installed one active IDSM in each chassis with identical configuration... what happens when one of them fails ?

Appreciate your Support.

3 Replies 3

Reza Sharifi
Hall of Fame
Hall of Fame

Hi Amro,

You would need to have one IDSM-2 in each chassis, because when the active VSS device fails the entire box will fail.

refer to this paper for more info on how to deploy IDSM in VSS:

http://www.cisco.com/en/US/products/ps9336/products_tech_note09186a0080a7c72b.shtml#idsm

HTH

Reza

Thank you Raza..

I have read the document. But what I am interested in is how the configuration would look like in case of Promescouse mode ot inline mode.

Regards,

Amro

Amro,

Did you ever get any  information about this?  I am also planning on implementing VSS with each chassis having an IDSM module.  Haven't figured out how to best deploy it (with configurations)

Thank you, Brian

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco