08-09-2010 06:31 AM - edited 03-06-2019 12:23 PM
Hi,
We are looking forward to install a Cisco 6513 with IDSM-2 in each chassis in a VSS mode. Does anyone have an experience with the configuration of the 6513 ? Also, lets assume I installed one active IDSM in each chassis with identical configuration... what happens when one of them fails ?
Appreciate your Support.
08-09-2010 07:13 AM
Hi Amro,
You would need to have one IDSM-2 in each chassis, because when the active VSS device fails the entire box will fail.
refer to this paper for more info on how to deploy IDSM in VSS:
http://www.cisco.com/en/US/products/ps9336/products_tech_note09186a0080a7c72b.shtml#idsm
HTH
Reza
08-09-2010 07:22 AM
Thank you Raza..
I have read the document. But what I am interested in is how the configuration would look like in case of Promescouse mode ot inline mode.
Regards,
Amro
01-15-2012 10:15 PM
Amro,
Did you ever get any information about this? I am also planning on implementing VSS with each chassis having an IDSM module. Haven't figured out how to best deploy it (with configurations)
Thank you, Brian
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide